to enroll in courses, follow best educators, interact with the community and track your progress.
37 lessons,
6h 52m
Enroll
857
GATE 2018 Set 2
92 plays

More

IRSME. Graduated in Mechanical engineering. Secured AIR 1 in ESE 2017. Believes in Quality Education for all.

U
bahut...bahut.. Shukriya Sir ji aapka way of teaching bahut hi shaandaar hai ... thank you sooooooo much...4/5
Thank you soooooooo much Neha for your kind words and your consistency :-)
Neha Singh
2 years ago
shukriya to humko aapka aur Unacademy ka karana chahiye..Jo itane achche teachers se milawaye Hai..bahut ... bahut ..... shukriya aapka
thanks sir
1. GATE 2018- Set 2 By: Lohit K Yadav

2. In a cam-follower, the follower rises by h as the cam rotates by (radians) at constant angular velocity (radians/s). The follower is uniformly accelerating during the first half of the rise period and it is uniformly decelerating in the latter half of the rise period Assuming that the magnitudes of the acceleration and deceleration are same, the maximum velocity of the follower is

3. allo om at i Pe atc

4. 2 2. 2. 2

5. 2 NV

6. A thin-walled cylindrical can with rigid end caps has a mean radius R=100 mm and a wall thickness of t-5 mm. The can is pressurized and an additional tensile stress of 50MPa is imposed along the axial direction as shown in the figure. Assume that the state of stress in the wall is uniform along its length. If the magnitudes of axial and circumferential components of stress in the can are equal, the pressure (in MPa) inside the can is decimal places) _(correct to two end cap end cap Pressurized can 50MPa 50MPa

7. Vem 'm'm P R

8. ij x loo a=lot

9. lo

10. A force of 100N is applied to the centre of a circular disc, of mass 10 kg and radius m, resting on a floor as shown in the figure. If the disc rolls without slipping on the floor, the linear acceleration (in m/s2) of the centre of the disc is (correct to two decimal places). 100N

11. ghe

12. So 1 2

13. N D N2 D1 YM D2 30x

14. 0 3 NDR 2.

15. Thank You